What is the speedest rubber there is?

[joerg.bolivien]

Originally posted by amok "orginal"
No, it isn´t! I swear!

729-2 is faster as bryce, sure!

When you have an old rubber ,send it to me I don't believe you.

By the way:
I think there are many short pimples which are faster than Bryce .
But are they asked about ??(das soll heißen:sind sie überhaupt gefragt ??)
IMHO the speediest short pimple ist Speedy Soft D.TechS

[Amok "Orginal"]

1. what´s your address?
2. 729-2 is no pimples-out-rubber

It´s a friendship with a special sponge.

PS: Nachfrage=demand

[joerg.bolivien]

Originally posted by Amok "Orginal"
1. what´s your address?
2. 729-2 is no pimples-out-rubber

It´s a friendship with a special sponge.

PS: Nachfrage=demand

OK ,I will send a private message to you.

[Defence]

I think, the Innova Prmium in 2,6 mm is the fastest rubber on earth.

[Sascha Eichmann]

The fastest rubber unglued should be the Bryce; but if they get glued originally all the - i call it maximum-rubbers- should be faster.

The fastest rubber is the one with the highest speed when smashed. Obviously that can only be a pimple-out rubber with a very hard sponge.

Bryce... young people...

WildWilbur

[TT Voodoo]

Let's approach the question from technical viewpoint:

Due to my experiences (over 50 types of rubbers) I suppose that both rubber and sponge are important in the field of accerelation. The fact that the pimples are out or in doesn't matter. There are two possible directions:
1. extra hard sponge with extra hard rubber.
2. everythig is soft.

Let's start from the 1st situation. If you have any Frendship rubber with yellow or blue sponge (even KAWA 2.2 extra hard sponge) your paddle is quiet dead but hard despite the amount of any kind of glue. In this case you cannot use anything else to accerelate the ball than your power. You had better use a piece of wood or baseball paddle.
The second arrangement has also the same problem because the ball sinks into the rubber and sponge to the wood and we arrived to the baseball paddle case again.

I am convinced that the most effective solution is rgarding the speed:
- 2.6 flexible but dense sponge that can accumulate the power of speed glue (sponge of Joola Terminator, Donic Supersonic M/S 40...etc.)
- a piece of rubber with a built in glue effect (Tensor or High Tension)
- Yasaka Super Speed or Bfly Master Chack glue

This is going to be a real destroyer because the above components add extra energy to catapult the ball in addition to your own power. The control is an other cup of tea...

Please, note that recently the "catapult effect" and speed has been shown in the mixed catalogues. You can compare the Frienship to another and vica versa.

The Friendship rubbers have only one advantage: its price.

Everything is relative

No one talks about the new stiga rubber neos. I guess it is the fastest because I play with neos sound witch is a little bit slower and it is allready extreamly fast. So when you would speed glue neos it's faster than bryce that's a fact

[shortytje]

I think the new carbo rubber of stiga with maximum sponge is faster than bryce. All the magazines of stores say so too.

[Bow]

Zitat von shortytje

I think the new carbo rubber of stiga with maximum sponge is faster than bryce. All the magazines of stores say so too.

Yes, but that is just commercial strategy. I play the Carbo and its a good Off-rubber, but its slower than e.g. the Innova. Carbo Sound is slower by far (I also played).