Vergleich: Butterfly Timo Boll ZLF vs. Jun Mizutani

[donicpiranja]

I used to play with:
hinokie/carbon frame with bryce speed(fh) en bryce speed fx(bh) both rubbers tuned...
For the new season I’m looking for a new blade en rubbers(must be butterfly), I want to play with tenergy 05 (fh) en tenergy 64(bh). Only problem is the blade, I’m thinking about 2:
Jun mizutani or boll zlf, it's for an all-out offensive game but I need the control and dwell time to produce heavy rotation on opening and enough control for the short game. Witch blade will come the closest to my needs?

[Simon F.]

i guess the mizutani

[RHmonster]

no question, I´d prefer the mizutani wood

[m3ch_rip]

Which hinoki/carbon frame did you play before?

Moreover i wonder, why you think about Jun Mizutani and ZLF, because the speed of these blades is different. The Jun Mizutani might be scaled on the upper site of blade category off, while the ZLF might be scaled on the lower site of this category.

Btw. the ZLC is mostly similar to the Jun Mizutani, these blades only differ in the wood type of the top sheet (ZLC = Koto, Mizutani = Limba).

[Niemalsaufsteiger]

Zitat von m3ch_rip

Which hinoki/carbon frame did you play before?

Moreover i wonder, why you think about Jun Mizutani and ZLF, because the speed of these blades is different. The Jun Mizutani might be scaled on the upper site of blade category off, while the ZLF might be scaled on the lower site of this category.

Btw. the ZLC is mostly similar to the Jun Mizutani, these blades only differ in the wood type of the top sheet (ZLC = Koto, Mizutani = Limba).

I agree. If you want a harder, stiffer blade which is imo just a little bit slower than the Mizutani, take the ZLF. I think the T64 will harmonize with the ZLF, the T05 with the Mizutani because of the sponge hardness.

[Spin Jim]

Several supplier say the ZLF harmonise the best with Tenergy rubbers.

[donicpiranja]

i was told by my supplier that the zlf and mizutani are the clossest to my "old"blade ( no name blad. with 3 layers hinoki 2 carbon, speed off).

if i want to use 2 sides tenergy 64(focus on spin) i should go for the zlf?

[Spin Jim]

Zitat von donicpiranja

i was told by my supplier that the zlf and mizutani are the clossest to my "old"blade ( no name blad. with 3 layers hinoki 2 carbon, speed off).

if i want to use 2 sides tenergy 64(focus on spin) i should go for the zlf?

That is what I read often.

[martin_hb]

I think, it depends on your preferences. Both are great blades and works imho great with tenergy rubbers. Maybe you have the opportunity to the test blades and decide which will be up to you.

[donicpiranja]

next week i will test both blades with tenergy 05 and 64. So i hope to find the right blade. I will right a review